INSTALLING AUTOTIGHT TAKE-UP DEVICES IS SIMPLE

THIS INSTALLATION GUIDE APPLIES TO ALL ALUMINUM AUTOTIGHT TAKE-UP DEVICE

STEP 1:
THREADED ROD
STEP 2:
BEARING PLATE
STEP 3:
TAKE-UP DEVICE
STEP 4:
NUT & WASHER
STEP 1
STEP 2
STEP 3
STEP 4
THREADED ROD MUST
BE INSTALLED PLUMB
BEARING PLATES MUST
BE INSTALLED FLAT
INSTALL THE TUD
WITH THE PIN OUTWARD
PLACE WASHER ON TUD
 FINGER TIGHTEN NUT

PULL ACTIVATION PINS RIGHT BEFORE ENCLOSING WALL

IF THE ACTIVATION PINS ARE PULLED PREMATURELY PLEASE CONTACT (360) 378 9484 FOR INSTRUCTIONS ON HOW TO RE-WIND THE TAKE-UP DEVICE